Mounting Shutters On Vinyl Siding

Step 3 add these two measurements together then add 1 2 inch.

Mounting shutters on vinyl siding.

So i don t really want to do that because if it doesn t work out then i have holes in my siding. Measure the same distance upward from the bottom of your shutters and make a mark on your siding for the next screw. Use a hammer to gently tap the fasteners to snug the shutter to the siding. Repeat this process for each shutter you ll be installing.

After removing the shutter drill a hole at each mark. Do not over tighten or this will cause the shutter to dimple. Place the vinyl shutter next to the window where you plan to install. Measure the thickness of the lap on the siding.

For wood vinyl or aluminum siding drill a 1 4 diameter hole through just the siding. To avoid warping don t attach the shutters tightly. So what i wanted to do is i wanted to put shutters on the house but i m not sure which color or which style. But the only way to fasten the shutters is to drill into the siding.

Grasp the shutter fastener supporting shank and push it through the shutter hold and into the wall surface. The top of the low end standardsized vinyl siding lo and industry experts predict that you need to go if. Installing in vinyl siding. Tap the shutter fastener gently with a hammer to snug the shutter against the siding.

Reposition the shutter. To remove shutters do not attempt to pull out the shutter spikes. Vinyl siding expands and contracts with the weather. Best solid surface shower pan to be about inches high.

Be careful not to drill into the wall. You ll need a masonry bit and masonry wall anchors or suitable spikes if provided with shutters. How to hang shutters on vinyl siding attach the shutters may end standardsized vinyl and inch diagonally from the market. Overtightening fasteners during shutter installation can create warping or dimples on the surface of vinyl.

Most vinyl siding is made to imitate wood lap siding so the lap of the siding is measured at the bottom of the simulated wood panel where the real wood would overlap each other. Mark the locations of the mounting holes on the building.