Lp 76 Series Smooth Lap Siding Installation Instructions

Lp smartside is the new high end siding of choice here in minnesota.

Lp 76 series smooth lap siding installation instructions.

It used to be stucco but moisture intrusion problems with stucco siding made many high end home builders start using james. We re building a new home sw virginia with 2x6 studs on 24 inch centers. Smartside 76 series 8 in. Check your local building code before starting to install the sid.

76 series lp smartside lap may also be applied over code approved nailable sheathing. Then i discovered that lp s installation instructions specify 1 5 inch x. Lp smartside 38 series lap siding may be attached over nailable. Use hot dipped galvanized nails with a minimum 0 270 in.

Lp smartside 38 series lap siding may be attached directly to framing members that are spaced up to a maximum of 16 in. It also provides better impact resistance than many other siding products. Nailing instructions lp smartside 76 series lap siding may be attached directly to framing members spaced up to a maximum of 24 in. Nailing instructions lp smartside 76 series lap siding may be attached directly to framing members spaced up to a maximum of 24 in 600 mm on center.

X 1 1 2 in 1 4 in. Smartlock self aligning lap should be installed in the same manner as 76 series lap siding. Lp smartside strand substrate panel siding. It s easy to install with a primed paint ready finish.

76 series lp smartside lap may also be applied over code approved nailable sheathing. Cedar strand lap siding resists rot and termites for added durability. How to install lp smartside trim siding. Nailing instructions lp smartside 76 series lap siding may be attached directly to framing members spaced up to a maximum of 24 in.

Check your local building codes before starting to install siding to confirm if wood structural panel wall sheathing is required. Download our helpful installation instructions and watch our informative how to videos. We knew we had to use the 76 series smartside product for the 24 inch centers. We had hoped to use 1 5 to 2 inches of eps rigid foam to the exterior of the sheathing then 3 4 inch x 4 inch plywood furring strips then lp smartside lap siding.

Penetrate structural framing or wood structural panels and structural framing a minimum of 1 1 2 in. Nail a starter strip wood lath or siding approximately 3 8 in. Above bottom chalk line and install first course of siding.